NOTE: This is NOT a POST beep code. This is after the box has been running awhile (either in Windows 7 or most recently after booting from the Memtest86 CD). Possibly, after it crashes, it then tries to reboot and then the 2 beeps? (If so, then the 2 beeps are POST related)
I searched, but didn't find anything that seems to relate to beep codes after the box has been up and running for awhile, and then crashes and gives a beep code. In this case, the beep code is 2 beeps, a pause, 2 more beeps, etc.
Question: Am I correct, to believe that this is because of a RAM DIMM that has failed, or, a bad RAM slot on the motherboard, or do those beeps indicate something else?
I believe it is a HW problem, and that I've eliminated the hard disk drive causing the issue, because the first thing I tried to do was run Memtest86 and after that ran for approximately 15 or 20 minutes, after booting from the Memtest86 CD, it crashed and then the 2 beeps.
Thank you, in advance, for your time and help! Lanny
Repetitive Beep Codes
2
No RAM detected.
NOTE: If you installed or replaced the memory module, ensure that the memory module is seated properly.