Hi
I just bought 2 x U2715H monitors to run in a MST DaisyChain configuration
I have enabled MST on monitor 1 and disabled it on monitor 2, I'm using proper DP1.2 certified cables
the monitors are firmware A02
Daisy Chaining is not reliable, I cannot get the 2nd monitor to go, it is not detected, and stays in Power Save.
Reading online in these forums it appears I need firmware A03, and that I can't flash it myself.
Is this a known issue?
is there a firmware A03 for the U2715H
I wish I knew all this before I bought these monitors
